Roller Pin Removal Tool - Clutch Roller Pin Extractor Removal Tool Compatible With Can Am Maverick X3 2017-2020

How to Use Clutch Roller Pin Extractor Removal Tool?·Install puller bolt and flat washer through puller plate.·The cut outs on the puller plate face the driven clutch sheave.·Thread the M4 set screw into the roller pin until it stops.·Make sure the two arms of the puller plate are sitting down into the cluth fins evenly on each side.This will assure that the puller is lined up straight with the pin.·Using two 3/4" wrenches hold the end of the puller bolt while turning the nut clockwise in towards the puller plate.This will pull the pin out.Compatible With:2017 Can Am Maverick X3 all models2018 Can Am Maverick X3 all models2019 Can Am Maverick X3 all models2020 Can Am Maverick X3 all modelsPart Included:2x m4 set screw2x m4 hex nut1x 1/2" hex nut1x 1/2" flat washer1x puller plate1x puller bolt10-Year WarrantyIf for any reason at all,you are not fully satisfied with the Roller Pin Removal Tool,you can contact us through amazon message for carefree REPLACEMENT or REFUND.

• 【𝗙𝗶𝘁】Clutch Roller Pin Extractor Removal Tool Compatible With Can Am Maverick X3 2017 2018 2019 2020.
• 【𝗙𝗲𝗮𝘁𝘂𝗿𝗲】This Roller Pin Removal Tool allows easy replacement of roller pins without damaging the clutch(No slide hammer necessary for removal.)
• 【𝗘𝗮𝘀𝘆𝗧𝗼𝗥𝗲𝗺𝗼𝘃𝗲𝗿】After the Pin Removal tool is installed，Using two 3/4" wrenches hold the end of the puller bolt while turning the nut clockwise in towards the puller plate.This will pull the pin out.
• 【𝗛𝗶𝗴𝗵𝗤𝘂𝗮𝗹𝗶𝘁𝘆】Our Removal Tool is made of high quality aluminum for increased strength,and anodized surface that is highly resistant to any bad weather,greatly prolong the service life.
• 【𝟭𝟬-𝗬𝗲𝗮𝗿𝗪𝗮𝗿𝗿𝗮𝗻𝘁𝘆】If for any reason at all,you are not fully satisfied with the Roller Pin Removal Tool,you can contact us through amazon message for carefree REPLACEMENT or REFUND.